Description
Between 1935 and the end of the war in 1945, the Luftwaffe developed approximately 10 versions of the Oxygen Mask, with almost all being based on the same design with small modifications. The 2 primary manufactures were Dräger and Auer. Adopted by the Luftwaffe in 1939, the 10-67 replaced the earlier 10-69 design which often had problems with freezing moisture from the exhaled air. Manufactured by Auer in Berlin the 10-6701 was designed for use with the LkpN101 and other flying helmets modified for 2-point mask attachment. Due to its light-weight construction and compact size, it found favour amongst many fighter and fighter-bomber pilots. While in the cockpit, t his mask and hose connected directly to the oxygen regulator, which was usually located on the starboard side of most aircraft. When the pilot needed to bail out, he then connected the secondary hose to the HAS 16 Hohen Atmer Sauserstoffgerat (see my other listings), which was stowed inside the seat parachute itself.Used only in late-war high altitude fighters, such as the Me262, Ta152, He162, Me163, and Do335! This near PERFECT example High Altitude Oxygen Mask is made primarily of moulded green rubber, with leather, bakelite, and aluminum accessories. Unlike most masks you encounter, this example features the ORIGINAL suede leather internally (almost all you find nowadays are replaced/refurbished as these have dried up or rotten away). Designed to fit snugly over the wearers mouth and nose, it also includes the original elasticized cotton strap, which allowed for secure fitting. Being a 2-point O2 mask, it was made specifically for fighter pilots, and attaches to the 2-point flight helmets. Complete with hose and clip (which was designed to clip to the pilots flight jacket or suit), these are also the originals to this mask. All rubber is still sold and soft, with NO cracking. Though there is some dirt and wear, there is NO damage, rust, or corrosion! Two corrugated rubber tubes extend from the lower section of the mask – one for the on-board Oxygen Regulator (Sauerstoffdusche); and the other for the HAS16 Parachute Oxygen Supply inside the parachute. The hose for the High Altitude Regulator appears to be made out of a different rubber, which is most likely designed to prevent freezing. Attached are both end fittings, and the original “crocodile” clip. All parts are in excellent condition! Only TWO of these Oxygen Masks are known to exist (this one being #2), making this an INCREDIBLE piece of history! As the High Altitude Parachutes sell in the $12000-$14000 range (and they come up every once in a while), I have priced this mask accordingly. Would make a PERFECT addition to any Collection or Display!Please email me if you need additional photos or information. |
Powered by SixBit’s eCommerce Solution